Unparalleled A+ rated 4-speed high-performance motor that uses as little as 1.2 watts of energy on night-time mode and only 6.3 watts on high boost
True silent operation with an ultra-low 3.6 dBA on night-time mode and 27.3 dBA on high boost
The heat of the unit is a quality ceramic heat recovery core that provides long-term performance of up to 90 heat recovery
Integral humidity sensor with 3 humidity monitoring levels. When a set humidity is reached, the device will enter exhaust mode to dispense excess humidity.
4-speed settings from 15 m3/hr to 60 m3/hr including a night mode for silent operation
3 Ventilation Modes
Set your unit up for any situation with a press of a button and will allow for either heat recovery of up to 90% or simply extract warm or humid air or even just supply fresh air in from outside
The unit comes with an IR remote control that allows you to control all the features on the one unit or any other additional units simultaneously
Filters & Maintenance
The system has been designed with extra quick and easy servicing of the two filters as the core and filters can be removed and cleaned without any tools or removing the outer covers
During operation, the inner grille will open depending on the chosen airflow rate and if the unit is not being used the grille will close over with a foam seal
Built-in Wi-Fi enables wireless pairing of multiple devices across your house, when paired devices will run either in parallel or in reverse depending on your setup. When the primary device is in ventilation mode, all parallel devices will also follow, while the reverse devices will be in exhaust mode. This way you can have continuous ventilation and aspiration and create air drafts inside or across rooms to increase the effectiveness of ventilation. You can set different settings and speeds for different rooms and create various ventilation zones.
Easy to install
Can be used as standard on walls from 250mm to 500mm and can be extended up to 1000mm with the pipe extension accessory. The pipe diameter is 165mm and recommends a hole diameter of 165 - 180mm